Engraving Machine Troubleshooting
1, the spindle motor short circuit, bad bearings, broken rotor, such as silk slip
2, limit switches and limit switches line perishable
3, Z-axis 608 is easy to bad bearings and couplings opened often leads to the Z-axis tool bar or shades
4, the pump is easy to sound or no water
5, prone to slip marks six months after compasses
6, Z axis screw length of time will be a big noise walking, walking up and down when the regular card
7, Z-axis and Y-axis dust-poor soils too
8, X-axis and Y-axis of the lead screw nut is easy to fall, the machine is easy to loose the top wire
9, easy to drive short-circuit, the stepper motor does not turn easily, off-axis, the vertical clearance should be noted that the use of engraving machine safe use of electricity
10, computer engraving machine can not send a signal